LED :: essays research papers

Q What is get (Light Emitting Diode)?A direct (Light Emitting Diode) is the most commonly utilize backlight for Cellular phones. The conduct backlight offers some benefits all over the EL backlight. To start, the lead backlight does not require an inverter, just a DC source of +3VDC+5VDC. Secondly, depending on the backlight configuration, the brightness privy very bright, and thirdly, the life of the take exceeds 50K hours.http//www.microtipsusa.com/content/Products_FAQS.asp17Abbreviation of light emitting diode, an electronic device that lights up when electricity is passed through it. LEDs be usually red. They are good for displaying images because they can be relatively small, and they do not burn out.http//www.webopedia.com/TERM/L/LED.htmlhttp//www.edgesystem.net/LED_light_therapy.htmA small indicator light most often used to show the power is on or the device is being used. LEDs are found on your computer case, monitor, printer, modem, CD-ROM drive, and hard drive.Wh at is In expression an LED?LEDs are special diodes that emit light when connected in a circuit. They are frequently used as "pilot" lights in electronic appliances to indicate whether the circuit is closed or not. A a puzzle out (or often colored) epoxy case enclosed the heart of an LED, the semi-conductor stoppage. LED leadsside lead on flatside of bulb = negative      The deuce wires extending below the LED epoxy enclosure, or the "bulb" indicate how the LED should be connected into a circuit. The negative side of an LED lead is indicated in two ways 1) by the flat side of the bulb, and 2) by the shorter of the two wires extending from the LED. The negative lead should be connected to the negative rod of a battery. LEDs operate at relative low voltages between astir(predicate) 1 and 4 volts, and draw currents between about 10 and 40 milliamperes. Voltages and currents substantially above these values can melt a LED mo. The most important pa rt of a light emitting diode (LED) is the semi-conductor chip located in the center of the bulb as shown at the right. The chip has two regions separated by a junction. The p region is prevail by positive electric charges, and the n region is dominated by negative electric charges. The junction acts as a barrier to the mix of electrons between the p and the n regions. Only when sufficient voltage is utilise to the semi-conductor chip, can the current flow, and the electrons cross the junction into the p region. In the absence seizure of a large enough electric potential difference (voltage) crosswise the LED leads, the junction presents an electric potential barrier to the flow of electrons.